Skip to content
Handy ToolsSound Level Meter

Sound Level Meter (Decibel Meter)

Press the button to measure the sound around you with your microphone and see its loudness (dB), main frequency, and frequency breakdown as numbers. Sound is analyzed only on your device and is never recorded or sent.

Press the button to measure the sound around you for 10 seconds. The first time, your browser asks for permission to use the microphone.

Sound is analyzed only on your device. It is never recorded or sent.

Right now

Loudness

—dB(A)

Instant peak

—

Main frequency

—

Strength by frequency (50 Hz to 16 kHz)

Settings

A matches human hearing (the standard for noise; counts low sounds less). C keeps low sounds almost as they are, and Z applies no weighting. Choose the same one as the meter you compare with.

Fast (0.125 s) follows changes quickly, and Slow (1 s) gives steadier readings. Max and min are taken from this value too.

Estimated dB = dBFS + offset. On iPhone and iPad the default matches a calibrated sound meter app; on other devices it's a rough value. After a measurement, use “Match a reference” to match your own sound level meter exactly. Saved on this device.

FAQ

Is the sound recorded or sent anywhere?
No. The microphone input is analyzed in your browser every 0.1 seconds and turned into numbers. The sound itself is never stored or sent. The microphone turns off automatically when the measurement ends or you stop it.
How accurate are the dB values?
They are estimates. Phone and computer microphones differ in sensitivity and aren't calibrated, so the estimated dB is the level the microphone picks up (dBFS) plus a calibration offset. On iPhone and iPad, the default offset was set by measuring side by side with a calibrated sound meter app; on other devices it's a rough value. If you have a sound level meter or a calibrated app, measure together and enter its value under “Match a reference” below the results to get the same reading. For measurements with legal or contractual weight, use a certified sound level meter.
What do dB(A) and L90 mean?
dB(A) is loudness weighted the way human hearing works (A-weighting), which counts very low and very high sounds less. It's the standard for noise. You can also switch to C-weighting (keeps low sounds almost as they are) or Z (no weighting) in the settings. As in the sound level meter standard (IEC 61672), the displayed level uses Fast (0.125 s) or Slow (1 s) time weighting. L90 is the level exceeded 90% of the time. It leaves out passing sounds such as voices or cars, so it shows the usual background noise of a place.
The readings look wrong or too low.
Some devices can't turn off the noise suppression or automatic gain made for calls, so quiet sounds may read lower than they are. Make sure the microphone hole isn't covered, and check that another microphone, such as Bluetooth earphones, isn't connected.